Page 6
SoundSource Owner’s Manual
Diagram 5:
Installation - Exploded View
Diagram 6:
Installation - Side View
1.
Rotate the Wall Mounting Bracket’s clamping dogs so that
they are inside the frame.
(See Diagram 4)
2
.
Slide the Wall Mounting Bracket into the rough opening of
the drywall.
3.
Rotate the dogs to the outside of the frame by hand, and
then slowly tighten the dog screws while holding them in
place by hand. If the wall thickness exceeds dog travel, turn
dogs upside down, reinstall screws, and proceed with install.
NOTE:
Do not overtighten screws or frame will distort.
4.
Make sure Wall Mounting Bracket is level and square.
5.
Remove screw access panel at top of SoundSource.
6.
CAUTION:
Before connecting any wiring, SpeakerCraft
highly recommends doing a “practice install” to make sure
the SoundSource locates properly into the mounting frame
and that the screw holes line up.
(See Diagram 5)
7.
Holding the SoundSource at a slight angle, slide it into
opening, engaging the locking tabs on the bottom of unit
with the cut-outs on bottom of the Wall Mounting Bracket.
(See Diagram 6)
8.
Push SoundSource flat against wall and check mounting
holes to see if they line up. If not, adjust frame squareness
and retighten frame.
9.
If everything lines up properly, connect wires to bottom of
SoundSource unit and reinsert into wall. (See “Connecting
The SoundSource” on Page 7.)
10.
Secure the SoundSource using the two mounting screws
provided. Because they are self-tapping, there will be an
initial resistance as the screw penetrates the metal bracket.
Be sure not to overtighten the screws.
CAUTION:
Do not
place screws into the larger holes. These are for snap-on
access panel only.
11.
Install snap-on access panel.
INSTALLING THE WALL MOUNTING BRACKET AND SOUNDSOURCE UNIT
Diagram 4:
Wall Mounting Bracket Dogs
