2
Wood Double Studs
Figure 2
Figure 1
B
A
Concrete
A
Figure 3
OR
H
I
Figure 4
Step 2:
Attach TV plate to the back of TV, choose corresponding bolt,washer to fix the holes
of TV rear, the assembly based on two conditions as below.
1,if the TV back is flat,please refer to figure 3 ;
2, if the TV back is not flat(curved or concave), please refer to figure 4.
Step 1
Hold wall plate (
) against wall at desired position on concrete wall, then using
a pencil mark 2 hole locations . Then drill holes according pencil marks using 2/5" or
10mm size drill bit to a depth of 2.36"/60mm . Then you will need to use wall anchors(B).
Insert wall anchors(B) into holes, you may need to use hammer to lightly tap wall anchors
into wall . Then fix wall plate(
) to the wall with screws (A) . (Figure 1)
Note:
The concrete wall minimum thickness no less than 100mm, and surface covering
can't more than 3/8 inches.
If you mount TV mount into wood studs ,pre-drill the mark 2 holes using 4mm drill bit to a
depth of 2.36"/60mm, fix wall plate (
) to the wall with screws (A). (Figure 2)
Note:
The wood stud min size is 2x4 inches, and surface covering can't more
than 3/8 inches.Drill hole on the wooden pillars middle line.
UP
H
I
E/F/G
K/L
J
