This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in
electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication represent the technical status at the time of printing.
Copyright 2018 by Conrad Electronic SE.
*1693320_v1_0718_02_IPL_m_en
b) Receiver
• Connect the receiver, for example, to the HDMI input of a monitor or projector.
• Connect one end of the network cable to the RJ45 socket.
c) Transmitter
• Connect the transmitter, for example, to the HDMI output of a laptop or Blu-ray
player.
• Connect the other end of the network cable to the RJ45 socket.
• Connect the transmitter via the enclosed USB cable to a USB connection to supply
power.
Normally, it is sufficient if you only connect the transmitter with a USB port.
The transmitter should then supply the receiver with power.
If the receiver is not working properly, connect it with a USB port.
d) Wiring Diagram
USB
CAT6
Transmitter
Receiver
Operation
• Turn on the playback device (e.g. Blu-ray player).
• Turn on the monitor or projector.
• Start playback.
Adjusting to the length of the network cable
• Use the LENGTH button to adjust the product to the length of the network cable.
• Press the button once or twice to automatically adjust the product.
• Press the button three to twelve times to manually select one of a total of ten preset
configurations.
• When you press the button again (i.e. 13 times), the cycle starts over from the
beginning.
The product saves the setting. When you turn the product back on, the
most recently selected configuration is preset.
Troubleshooting
No picture or poor transmission quality
• Turn all devices on.
• Check all the connections.
• Check the network cable.
• Select the correct input on the television.
• Disconnect the transmitter from the power supply for a few seconds.
• Press the LENGTH button.
Care and Cleaning
• Disconnect the product from the connected devices before cleaning.
• This product does not contain any components that require maintenance. Never
attempt to open or disassemble it.
• Never use aggressive detergents, rubbing alcohol or other chemical solutions, as
these could damage the housing or stop the product from functioning properly.
• Use a dry, lint-free cloth to clean the product.
• Dust can be easily removed using a soft and clean long-haired brush.
Disposal
Electronic devices are recyclable waste and must not be disposed of in
the household waste. At the end of its service life, dispose of the product
according to the relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to protection of the
environment.
Technical data
Suitable network cable ........... CAT6/6A/7, max. 50 m, RJ45 plug
Suitable HDMI cable ............... max. 5 m
Compatibility ........................... HDMI1.3, HDCP1.2
Supported resolution .............. 480i (60 Hz), 480p (60 Hz), 576i (50 Hz), 576p
(50 Hz), 720p (50/60 Hz), 1080i (50/60 Hz), 1080p
(50/60 Hz)
Supported audio format .......... L/R stereo
Transmission rate ................... max. 10.2 Gbps
USB cable length .................... 1 m
Operating conditions ............... 0 to +50 °C, max. 90 % RH
Storage conditions .................. -10 to +70 °C, max. 90 % RH
Dimensions (L x W x H) .......... 71 x 26 x 16 mm
Weight .................................... 19 g (transmitter), 17 g (receiver)
