www.spatz-tech.com
23
by the device. Please refer to the details in Chapter 6
Audio Bit Rate
Support
.
No Supported Video
/Audio on WIDE mode
only.
Check the HDMI output setting of Source device, setup HDMI output
format to Auto mode instead of 1080p.
Check Chapter 5: “Supported Resolution”. Some resolution can’t be
supported on WIDE mode on.
IR Blaster can’t control
Source device.
Make sure IR Blaster sensor is close by or attached to source device’s
IR sensor. Please refer to Chapter 3’s Step3 for reference setup.
Change IR Blaster frequency to meet Source device’s requirement.
Please press Source key on top of the Receiver/Transmitter or RCU
to switch IR Blaster frequency 47K to 58K to 38K recurring.- The OSD
shows: (Display 5secs)
▃▆█
HDMI1 CH1 WIDE Off 1280x1024
IR Blaster Frequency [47KHz]
Press Source key on the top of Receiver again to switch IR Blaster
frequency.
