Spartan Easy Stinger 2804, User Manual

Page: 4 / 5

1. UNPACKING AND INSPECTION
The Spartan stringing machine is packaged and shipped in one carton and is protected
internally by foam inserts. The Spartan stringing machine is packed with the following
components.
One machine base assembly, one tensioner post assembly, one tension rod, one tension
weight assembly (including two tension weights), one turntable assembly, two mounting
stocks (including two side-support arm assemblies), two mounting post assemblies, two
string clamps, one user's manual
Accessories:
four K-shaped side supports, one 6mm Allen wrench (hex wrench), one 3mm
Allen wrench (hex wrench)
Before unpacking any carton, inspect the carton for damage. Unpack the Spartan
stringing machine from the shipping carton by using the following procedure.
Step 1.
Cut the carton sealing tape and open all the carton flaps.
Step 2. Remove the top packing protector.
Step 3. Carefully lift the turntable assembly and tension rod out of the carton.
Step 4. Remove the, two mounting stock assemblies, two string clamps and accessory bag
out of the carton.
Step 5. Remove the tension weight assembly out of the carton.
Step 6. Carefully lift the tensioner post assembly and the machine base assembly out of
the carton.
Step 7. Inspect the Spartan stringing machine for obvious damage.
Step 8. Remove the bottom packing protector out of the carton. The accessories
sometimes fall beneath the packing protector.
This Spartan stringing machine has been assembled and tested in production line. After
passed the inspection by the quality control department, this Spartan stringing machine
was disassembled into a few major components and packaged into boxes for shipment.
NOTE : The Spartan stringing machine was pre-assembled and tested in the production
line. Therefore, there are the assembly marks on the machine base, turntable and tension
rod.
If any item is missing or damaged, contact your delivery agent and your sales representative.
Retain the packaging materials and shipping container in the event that reshipping is
required.
2. INSTALLATION PROCEDURE
Step 1. Place the Spartan machine base assembly firmly on the table. Mount the
tensioner post on the base. Line up two holes of the tensioner post with holes in
the base. Use the 6mm Allen wrench to lock it in place by tightening these two
screws.
Step 2. Make sure the machine base rests evenly on the table. If necessary, adjust the
level adjustment pad to level the machine base.
Step 3. Lower the tension rod to the right side.
Step 4. Use the 10mm wrench to turn the tension rod holding screw clockwise to lock it
in place.
Step 5. Mount the turntable on the turntable base. Line up four holes of the turntable with
holes in the turntable base. Use the 6mm Allen wrench to lock it in place by