STEP 10
Feed the pedal spindle with
the pedal attached through
the holes at the frame. Slide
a rubber washer (pt.37), the
second pedal (pt.39) and
then another rubber washer
(pt.37) onto the spindle and
lock them in place with the
remaining large nut (pt.38).
STEP 11
Feed the computer cable
(pt.13) through the hole in
the top of the main frame
tube and plug it into the
sensor cable (pt.27). Peel off
the backing strips from the
velcro pads underneath the
computer, and while pulling
excess cable through the
hole stick the computer to
the frame.
STEP 12
Making sure that the sensor
cable is out of the way push
the plastic cap (pt.7) into
front end of the main frame
tube. Repeat this with the
second cap at the rear of the
frame.
