10
MOUNTING THE MAIN ALARM MODULE
Locate a mounting position for the alarm in the vehicle engine compartment close to
the front of the vehicle and in a position where it is difficult to again access to the
alarm wiring from below the car.
Ensure that the alarm is located away from extreme heat, areas subject to water and
at least 12” from the ignition system. (Use silicone sealant enclosed when refitting
boot).
Using the alarm bracket as template, drill 2 holes and secure the bracket to the car
body-work using the self tapping screws provided, making sure the alarm bracket is
solidly mounted.
Check behind any panels for hidden pipes or wiring before
drilling holes. Secure the alarm to the bracket using the small bolts supplied making
sure that front face of the alarm is kept vertical to ensure effective operation of the
shock sensor.
HARNESS LOCATION
Position the harness to the rear of the main alarm module and secure where
necessary to the vehicle wiring using insulation tape.
Plug in the main harness connector to the rear of the alarm unit .
Do not fit the rubber boot to the alarm at this stage.
You can now make connections to the car wiring as shown.
All wires MUST be connected in the sequence outlined in these instructions.
Summary of Contents for SRA8
Page 11: ...11 SRA8 WIRING CONNECTIONS ...
