©2020 DS Services of America, Inc.
Fig 8
Fig 9
Fig 7
8. Wearing gloves, feed the new bottle
tube through the hole indicated
(Fig 7)
.
9. Insert the new SmartFlo™ cartridge
and secure into place by pressing
down
(Fig 8)
.
10. Rotate the blue knobs to the closed
position. Close and latch the blue
locking arm
(Fig 9)
.
11. Close the cooler lid by pushing
down to lock into place.
12. Wearing gloves, carefully unpack
the new bottle adaptor. Pull the
adaptor tube to straighten
(Fig 10)
and insert it into a new water bottle.
13. Feed the tube into the water bottle
until it reaches the bottom.
14. Remove the red protective cap from the bottle tube
(Fig 11)
. Install it into the bottle
adaptor
(Fig 12)
.
15. Slide water bottle into the cabinet and close the door.
16. Clean the cabinet, bottle receptacle and spigots with 70% rubbing alcohol or
disinfecting wipes. Vacuum or wipe the grill on the back of the dispenser to remove
any dust.
TIP:
The cooler exterior should be cleaned every 6 months.
17. Clean the drip tray and grill by emptying the tray and cleaning the tray and grill
with mild soap or by placing them on the top rack of the dishwasher
(Fig 13)
.
TIP:
The drip tray and grill should be cleaned monthly.
18. Wipe down the cooler and the surrounding area to dry any water spills.
19. Wash your hands thoroughly with soap and water for at least 20 seconds. Install a
full water bottle on the dispenser. Turn on the hot water tank switch.
20. Prime the dispenser to fill the reservoir by holding down the cold water spigot for
1 minute, or until water flows continuously. Repeat with the hot water spigot until
water flows continuously.
WARNING:
Dispense water through the hot and cold
spigots. Failure to follow proper installation instructions
may cause damage to water dispenser.
Load water
bottle FIRST.
1
Dispense
water from
hot and cold
faucets.
2
Bottle
Tube
Fig 12
Fig 11
Fig 10
Fig 13
