Install the caster wheel using the Phillips head screws and nuts included with the 3/8 in caster ball assembly. The
holes on the caster assembly are spaced to fit snug on the innermost segment of the angular slots near the rear of
the lower plate on the JetBot chassis. Again, hand tight is just fine.
Note: if you over tighten these screws it will
prevent the ball from easily rotating in the plastic assembly. However, too loose and it may un-thread; go
for what feels right
After you have installed the caster & aluminum standoffs, thread the motor wires through the back of the chassis
standoffs for use later.
2. Camera Assembly & Installation
Unpackage the Leopard Imaging camera & align the four holes in the acrylic mounting plate with those on the
camera.
Note: ensure that the ribbon cable is extending over the acrylic plate on the edge that does not have
mounting holes near the edge; as shown below.