P R E C AU T I O N S
This product must be only installed by a Licensed Electrician. Please make sure the mains supply is isolated
before commencing installation. Check the unit labels for correct supply voltage and frequency.
INSTALLATION INSTRUCTIONS
2. B dia-cut
solution:
Step 1.
Remove the product from the box and inspect it for any damage. If you believe the product
to be damaged or otherwise unsound,
DO NOT
install the fitting.
Please pack it back into its box and return it to the place of purchase for replacement.
Step 2. Choose the LED panel size that is suitable for your application.
65-70mm cut out for the 85mm panel
or
75-125mm for the 140mm panel
.
Note that this product can be installed into an existing cut out in the ceiling ranging from
65mm to 125mm.
For the smaller
65-75mm
panel, remove outer ring by twisting the outer ring out of its
locking position and sliding the outer ring down the loom.
Step 3. Put the inverter and battery into the ceiling, fix it onto the ceiling by self-tapping screws.
Step 4. Connect the LED panel connector.
Step 5. Connect the battery connector.
Step 6. Once the LED Emergency Light is Installed/Plugged Into Mains Power, ensure the loom
goes through the cutout into the ceiling. Pull back the two spring clips so they can fit through the
ceiling cutout. Release the spring clips, ensure the dish is secure and flush up against the ceiling.
Step 7. Turn on the mains power, check if the LED Indicator on the LED Emergency Light is “ON”,
if not check if the connectors between the inverter and the LED Emergency and/or battery is
securely connected and the mains power is turned on. Press the “TEST” Button, if the LED Chip
“light up” then the installation is successful and complete.
Step 8. Finally, THE INSTALLER MUST Charge the fitting for a minimum of 24 Hours without
disconnecting Power.
AC 220V-240V
65 - 75 mm opening
75 - 125 mm opening
AC 220V-240V
LED panel dia.: 140 mm
LED panel dia.: 85 mm
BATTERY
BATTERY
1. A dia-cut
solution:
-2-
This is a mains powered product. Before Installation or maintenance, please make sure power supply is
isolated. If the external flexible cable of this luminaire is damaged, it should only be replaced by a licensed
electrician or equivalent qualified person to avoid any safety hazards.
This luminaire is intended only for mounting in locations where the plug and sockets are protected from
unauthorised disconnections.
S A F E T Y
