Spanset HH250150P, Installation And Operating Manual

Page: 15 / 28

15.
7. MAINTENANCE
Periodically, or at least once every year, and in accordance with the safety regulations applicable in the
country of use, the hoist must be inspected and tested with load by qualified maintenance personnel.
Periodically, and especially after an intensive use, lubricate the mechanical parts. Never let brake discs
receive some lubricant. They have to be kept clean and dry. Check regularly the condition of the hooks with
the opening indicator of the hooks, particularly in case of overload. If any damage is observed, return the
HH250150P hoist to a SpanSet-approved repair workshop.
8. EMERGENCY PROCEDURE IN CASE OF AN INCIDENT
In the event of a blocked chain or any other malfunction of the unit, immediately stop the maneuver without
attempting any further actions and call in the necessary qualified personnel to remove the load and inter-
vene on the hoist. Immediately set up a safety perimeter around the hoist and directly under the load to
prevent access by any unauthorized persons. Return the hoist to a SpanSet approved repair agent.
9. DO NOTS
Do not:
- Use the hoist if it has not been inspected for more than 1 year.
- Use the hoist if its chain shows any deformation or wear.
- Use the hoist with any chain other than a genuine SpanSet chain.
- Use the hoist with an extension on the actuating handle.
- Use the hoist if the chain is not correctly positioned in the lifting mechanism.
- Make any changes to the hoist.
- Use any parts or components other than genuine SpanSet parts and components.
- Use a hoist which is not in good condition .
- Use the hoist without first having perform the checks described in this manual.
- Secure the hoist to a support which is not sufficiently strong.
- Secure the hoist by any means other than its suspension hook.
- Clamp the suspension hook.
- Attempt to lift fixed or blocked loads.
- Set the selector lever to the “0” position when the chain is tensioned .
- Use a high pressure cleaner or chemical products (acids, chlorinated products) to clean the hoist.
- Use the hoist at loads exceeding its working load limit (WLL).
- Use the hoist in an explosive environment (device not compliant with ATEX directive) or in a highly
corrosive environment.
- Use the hoist at temperatures of less than –10°C or greater than +50°C .
- Use the hoist to lift a load when the wind speed is greater than 50 km/h.
- Use the hoist, even occasionally, to lift or move persons.
- Use the hoist for operations other than those for which it is intended or using setup diagrams other than
those described in this manual.
EN