14.
4.3 MANEUVERING THE HOIST
1. To lift, pull or tension: put the selector lever to position
and operate the lever handle back and forth.
For a hoist equipped with the load limiter option: if the load is greater than 1.3 x WLL (average), the
operator’s action on the lever will not have any effect on the load and, under these conditions, it will be
impossible to lift the load. Important : Repeated triggering of the limiter can result in wear causing a
decrease in the load limitation threshold. In this case, the unit must be checked by SpanSet.
2. To lower or slacken: put the selector lever to position
and operate the lever handle back and forth.
4.4 IMPORTANT ADDITIONAL INSTRUCTIONS
1. When taking the HH250150P hoist out of service ensure that there is no load applied and that the load
chain is slack enough to enable the bottom hook to be removed from the load.
2. The selector lever must not be left in the neutral position “0” when a load is suspended or the hoist
is tensioned. Make sure that the selector lever is in the desired position and is not located between two
positions.
3. Do not attempt to operate the load wheel during any operation or when a load is suspended on the hoist.
4. It is not recommended to operate the lever handle at excessive speed as this will lead to an uneven
movement of the load. It is recommended to operate the lever handle in a steady movement to prevent
any unnecessary jerking of the load.
5. STORAGE
It is recommended that the hoist be stored hanging so that the load chain does not become tangled. Store
the hoist in a dry and weatherproof area. Before storage clean the load chain with a brush and lubricate
with machine oil.
6. LOAD CHAIN
The good condition of the load chain is a guarantee of safety and at the same time the good operation of
the hoist. It is therefore necessary to constantly be aware of the condition of the load chain and to clean
and lubricate with machine oil at regular intervals. The load chain must be examined daily by a competent
person when the hoist is being used . Do not expose the load chain to excessive temperatures, abrasive
materials or chemicals. Protect the chain against all possible damage such as from welding arcs.
EN
Summary of Contents for HH250150P
Page 26: ...Notizen Notes Remarques ...
