SAFETY WARNINGS - Risk of Electrical Shock
Ÿ
The pump must be installed in a weatherproof enclosure such as under a spa skirt. The pump
should be installed in an enclosure such that all electrical connections cannot be accessible to
the user without the use of a tool.
Ÿ
Power connections and wiring must be carried out by a licensed electrician. In all cases
conform to all national, state and local wiring rules and/or codes of electrical practice in effect
at the time of installation.
Ÿ
The appliance must be connected to a suitable rated and weather protected power supply.
Means for disconnection must be incorporated in the fixed wiring in accordance with your
local wiring regulations, to allow disconnection of the appliance from the supply after
installation. Means for disconnection from the supply mains should have a contact separation
in all poles that provide full disconnection under over voltage Category III conditions.
Ÿ
Ensure that an electrical isolation switch is located with easy access so that the pump can be
switched off in an emergency.
Ÿ
This is a Class 1 appliance and must be connected to protective earth.
Ÿ
This appliance should be supplied through a residual current device (RCD) having a rated
residual operating current not exceeding 30mA.
Ÿ
Refer to AS3000 wiring rules (Aust. & NZ) and IEC60364 Part 7 (Europe) or equivalent for
guidance with compliance to the wiring codes for wet area and equipotential bonding.
Ÿ
If the supply cord is damaged it must be replaced by the manufacturer, its service agent,
licensed electrician or similarly qualified persons in order to avoid a hazard.
Ÿ
No part of this appliance is to be located directly above the spa pool and must be inaccessible
to a person in the spa pool. All parts must be fixed so they cannot fall into the spa pool.
Ÿ
DANGER! Pump suction is hazardous and can trap and drown or disembowel bathers.
Do not block suction points. Do not use or operate swimming pools, spas or spa baths if
a suction cover is broken, missing or loose. Two suction covers and inlets must be
provided into every pump to avoid suction entrapment.
Ÿ
If the pump is located below water level, it is recommended to fit isolating valves in the pipe
work between the pump and the suction inlet and in the return pipe from the pump to the
pool.
Ÿ
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Ÿ
Children should be supervised to ensure they do not play with the appliance.
!