Page 14
Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Rail Section 3:
Step1:
Starting at the top Elevator Ring connect Rail-B
(27 cm) to Rail Clip at the back. Keeping Rail tight connect
through Arm H-6 and attach the Rail to the Rail Clip on single
side of the Rail Splitter C. Repeat for second rail.
Step2:
Start by attaching Rail H (480 cm) to the inside Rail Clip
of Splitter-C facing the front of the Base. Keeping Rail tight
connect through Arm L-7. Next start a vertical nested loop
where each successive loop is slightly smaller than the one
before it beginning with Arm O-11. Continue with Arms P-8,
N-8, O-9, P-7, N-7, O-8, P-6, N-6, O-7, P-5, N-5, O-6, P-4, N-4,
O-4, P-3, N-3, O-3, P-2, and exit loop to Arm N-1. Continue to
exit through Arms L-1, H-1, D-1, A-1, and G-1. Finish at Rail
Clip on Elevator Ring 1 at the back of the elevator. Repeat
step for second rail.
Step1:
Step2:
NOTE:
If length of rail is longer or shorter than
expected try adjusting the size of the nested
loops to better utilize the rails.
This top view of the nested loop section shows how each successive loop is
slightly smaller than the one above it. Start with a loop of about 20 cm and
work down to about 17 cm on the bottom loop. These numbers are intended
to be a guide only. Test your loops with the Marble. Adjust until you get good
consistent speed throughout this section.
Splitter C
