Seaich Corporation, LLC. All rights reserved. www.seaich.com | Spacerails, LLC. www.spacerails.com
Page 13
B
INSTALLING RAIL
Rail Section 1 & 2:
Splitter B
Splitter A
Step1:
Install one side of a rail at a time. Starting at the
top Elevator Ring on the Left side Rail Clip connect Rail-E
(100 cm). Keeping Rail tight connect through Arm D-9, B-7,
A-4, C-4, G-4, and H-4. Next attach the Rail to the Rail Clip
on single side of the Rail Splitter B. Repeat this step for the
second rail.
Step2:
Starting at the top Right Elevator Ring Rail Clip
connect Rail-A (15 cm). Next attach the Rail to the Rail Clip
on single side of the Rail Splitter A. Repeat for second rail.
Step 3:
Attach Rail F (341 cm) to the inside Rail Clip of
Splitter-A facing the front of the Base. Keeping Rail tight
connect through Arm M-8 and down to Arm R-1. Next start
a nested loop where each successive loop is slightly smaller
than the one before it. Continue with the inside rail connect
Arms W-6, V-6, W-5, V-5, W-4, V-4, W-3, V-3, W-2, V-2, W-1,
and V-1. Exit loop to Arm S-1 and continue around coaster
to Arms T-1, R-1, O-2, M-2, and finish at Rail Clip on Elevator
Ring 2 on the right side. Repeat step for second rail.
Fine Tune:
Once each Rail Section is completed run a
marble down your course and make sure ball travels well.
Make any adjustments as needed. Do not worry about
adjusting splitter until all Rails have been connected.
Step1:
Step2:
Step3:
NOTE:
Start with a loop of about 10 cm on the front and work
down to about 6 cm on the back loop. These numbers
are intended to be a guide only. Test your loops with
the Marble. Adjust until you get good consistent speed
throughout this section.
