Space-Ray PCA-SS 100, Assembly, Installation And Operation Instructions, Page: 16 / 62

Form 43343110
May 2021
-15-
8.3) ANGLE MOUNTING OF HEATERS
1. Angle mounting can be accomplished by using the loop portion of the wire hanger shown below to attach the
suspension components. This will produce an angle of approximately 30 degrees from the horizontal plane.
All suspension components can be used as outlined above in the TYPICAL SUSPENSION METHODS section.
Angle mounting can result in up to 30 % lower radiant output on the floor level and result in lower tube
temperatures when compared to horizontal mounting. Angle mounting of straight tubes for spot or area
heating (e.g. where a single heater is used for space heating) is not recommended unless you have additional
capacity or larger heaters specified/installed. If you are using straight tube heaters, you might have to install
two smaller size tube heaters with burners located at opposite ends, to provide more uniform energy
distribution and improved comfort level on the floor. Consult your Space-Ray Representative if you have any
questions prior to the installation concerning particulars of your application.