General Maintenance
VirTis BenchTop Pro
24
Rev 002, 01/14
© SP Scientific 2014
Clearing the Vacuum Pump Maintenance Alarm
The Vacuum Pump Maintenance Alarm will generate after the number of vacuum
pump running hours (
i.e.,
Current Hours) has exceeded the Vacuum Pump
Maintenance Alarm Setpoint, both of which are located on the Vacuum Pump
Maintenance screen. Before the alarm is cleared, check if any routine maintenance is
needed for the vacuum pump (
e.g.,
oil needs to be changed). Once the vacuum pump
is checked and any needed maintenance is complete, the Current Hours may be reset
and the alarm may be cleared. To reset the Current Hours and clear the alarm:
Ensure that the System Status screen on the Omnitronics™ controller is
1.
open.
Press the
MENU
button.
2.
Press the
Maintenance
button.
3.
Press the
Vac Pump Maint
button.
4.
Press the
VAC
Reset
button. A confirmation popup will open.
5.
Press the
YES
button to set the Vacuum Pump Current Hours to zero (0).
6.
Press the back button twice to return to the Main Menu screen.
7.
Press the
Alarms
button on the Main Menu screen.
8.
Press the
Active Alarms
button.
9.
Press the
magnifying glass
button(s) and locate the Vacuum Pump
10.
Maintenance Alarm.
Press the
Reset
button for the Vacuum Pump Maintenance Alarm.
11.
Press the
Esc
button to return to the Alarms Screen.
12.
Press the back button twice to return to the System Status screen.
13.
Scheduling Oil Changes
After clean oil is loaded into the vacuum pump and all necessary connections have
been made between the vacuum pump and the freeze dryer, perform a full capacity
test cycle.
Have a qualified technician check the oil after the test cycle. If the oil appears dirty,
change the oil after every use. If the used oil appears clean, change the oil after the
next two uses or cycles. If the oil remains clean after two cycles, change the oil after
the next four cycles. Continue to monitor the vacuum pump oil after each cycle until a
change of condition is noted or a period of one month has elapsed. If the oil remains
clean after several cycles, changing the oil once per month may be sufficient.
Vacuum Tubing and Gaskets
Inspect tubing and gaskets periodically for signs of wear. Check gaskets by removing
and inspecting interior surfaces for potential problems. A light coating of vacuum
grease on the exterior surfaces will protect gaskets and tubing. Reapply grease as
needed.
Summary of Contents for VirTis BenchTop Pro Series
