Hardware Installation
SY-7VCM
49
This is because the recorder and microphone in the Windows are not
enabled. Please go to sound properties and enable them.
Lock up (freeze)
When I boot up my system, everything works fine. It sees my CPU
and memory, detects my hard drive, floppy drive and CD-ROM but
locks up at "Verify DMI pool data... ", and it won’t go any further.
What should I do?
Please clear the CMOS via JP5 then choose 'load setup default' in the bios
and save the bios and exit. Next, unplug all other add-on cards except the
video card and floppy drive controller, and see if it can boot from floppy.
Then put back the peripherals one by one to identify which one causes the
lockup. If you are running a Cyrix CPU, make sure the 'linear burst
function' is enabled in the bios.
I can not get my board to run properly.
Please make sure you have the latest bios and driver from the SOYO web
site at:
http://www.soyo.com
2-3.8 Power Off
There are two possible ways to turn off the system:
1.
Use the
Shutdown
command in the
Start Menu
of Windows 95/98
to turn off your computer.
2.
Press the mechanical power-button and
hold down for over 4
seconds,
to shutdown the computer. If you press the power-button for
less than 4 seconds, then your system will enter into
Suspend Mode.
You are now ready to configure your system with the BIOS setup program.
Go to
Chapter 3: BIOS SETUP
Summary of Contents for SY-7VCM
Page 99: ...95 ...
