SOYO SY-6KL, Quick Start Manual, Page: 8 / 16

SY-6KL Quick Start Guide
8
Hardware Installation
Step 3.
Configure Memory
Your board comes with three DIMM sockets and two SIMM banks, providing support for up
to 384MB of main memory using DIMM modules from 8MB to 128MB and SIMM modules
from 8MB to 64MB with no restriction on memory configuration. Therefore, you can install
memory modules in any combination.
For 66MHz front side bus CPUs use 12ns or faster memory.
Memory Configuration
SIMM Bank DIMM Banks MEMORY
CONFIGURATION
Bank 0 DIMM 1 DIMM 2 DIMM 3
RAM Type EDO EDO/SDRAM EDO/SDRAM EDO/SDRAM
Single RAM
Module Size (MB)
8/16/32/64 8/16/32/64/128 8/16/32/64/128 8/16/32/64/128
Notice 1: You must always install two (2) SIMM modules to complete the SIMM bank.
Notice 2: Do not install memory modules in SIMM and DIMM 3 at the same time.
Step 4.
Set the CPU Frequency
You do not need to set any jumper for the CPU frequency. Instead, CPU setting are changed
through the BIOS
[CHIPSET FEATURES SETUP]. Please refer to Chapter 3 - Quick BIOS
Setup for details on how to set the Pentium
®
II processor frequency.
Step 5.
Enable/Disable PS/2 Keyboard Wake-Up (JP12)
You can choose to enable the Wake-Up by PS/2 Keyboard or Mouse function by shorting
pin 1-2 on jumper JP12, otherwise, remove the jumper cap to open pin 1-2 and disable this
function.
Support Wake-Up
by Keyboard
Enable Disable* (*Default)
JP12 Setting
Enable Wake-up
by Keyboard or
Mouse function
(short pin 1-2) Disable Wake-up
by Keyboard or
Mouse function
(open pin 1-2)
Important: When using the PS/2 Keyboard Wake-Up function, please make sure the
ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to
meet the standard ATX specifications.