Hardware Setup
SY-6IEB
26
Step 14. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
After you have turned off your computer, clear the CMOS memory by
momentarily shorting pin 2-3 on jumper JP5 for at least 5 seconds. Then
permanently short pin 1-2 to retain new settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Retain CMOS Data
Clear CMOS Data
JP5
Setting
Short pin 1-2 to
retain the new
CMOS settings.
Short pin 2-3 for
at least 5 seconds
to clear the CMOS.
Note:
You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 15. Power-on by Keyboard Jumper (JP10)
You can choose to enable the Power-on by Keyboard function by
shorting pin 1-2 on jumper JP10, otherwise, short pin 2-3 to disable
this function.
Wake-Up by
PS/2 Keyboard
Enable
Disable
JP10 Setting
Short pin 1-2 to enable
the Wake-Up by
Keyboard function.
Short pin 2-3 to disable
the Wake-Up by
Keyboard function.
Note:
When using the Power-on by Keyboard function, please
make sure the ATX power supply can take at least 720mA load on
the 5V Standby lead (5VSB) to meet the standard ATX specification.
2
1
3
2
1
3
2
1
3
2
1
3
Summary of Contents for SY-6IEB
Page 1: ...SY 6IEB Mainboard User s Guide Technical Reference...
Page 70: ...67...
