28
BIOS Setup
PM Control by
APM
Choose
Yes
(default) or
No
. APM stands for
Advanced Power Management. To use APM,
you must run Òpower.exeÓ under DOS v6.0 or
later version.
Video Off Option
Susp, Stby
→
off: Video off when the system
runs into Suspend or Standby
mode.
All Modes
→
off: Video off in all modes.
Always On:
Video never off.
Suspend
→
off:
Video off when system runs
into the suspend mode.
Video Off Method
Choose
DPMS Support (default), Blank
screen, or V/H Sync+Blank
for the selected
PM mode.
Modem Use IRQ
Choose Modem IRQ Setting. Default setting is
set on IRQ3.
Soft-Off by PWR-
BTTN
Choose
Instant-off
(default) or
Delay 4 Sec
.
Delay 4 Sec
turns off the system power 4
seconds after pushing the power button
HDD Power Down
When the set time has elapsed, the BIOS sends
a command to the HDD to power down, which
turns off the motor. Time is adjustable from 1
to 15 minutes. The default setting is Disabled.
Some older model HDDs may not support this
advanced function.
Doze Mode
When the set time has elapsed, the BIOS sends
a command to the system to enter doze mode
(system clock drops to 33MHz). Time is
adjustable from 1 Min to 1 Hour.
Standby Mode
The default is Disabled. Time is adjustable
from 1 Min to 1 Hour.
