SECTION 3: USING THE HOTPLATE
The graphics on each control knob clearly show which gas burner will be operated. Press
in the control knob and turn it to the maximum setting and light with a spark igniter or a
lighted taper. Once the burner is alight turn the control knob to the required setting.
Once you have finished using the burner, turn the control knob off – setting ‘0 ’. Never
use pans with concave or convex bottom surfaces.
SECTION 4: USING THE GRILL
The grill only has one heat setting, it creates heat at a constant rate. Press the oven
control knob and turn it clockwise to the grill setting and light the grill (situated in the top
of the oven)with a spark igniter or lighted taper. As the grill valve is equipped with a
Flame Failure Device (FFD),you should keep the knob pressed for 3-5 seconds. Once
you finished using the grill turn the control knob anti-clockwise back to the off position
–marked ‘0 ’.
Please note:
Whilst grilling, you must fit the Heat Deflector plate (supplied with your cooker) to ensure
that the control knobs do not get discoloured and/or damaged. Before you grill fit the
Heat Deflector to the underside of the fascia panel. The two slots in the panel align up
with the two screws/washers on the underside of the fascia panel. Carefully slide the
deflector in place above the screws/washers. If the screws are too tight, simply slacken
them off half a turn with a screwdriver.
Assembling Grill Heat Shield
G rill heat shield w ashers
S E E D E TAIL A
D E TA IL A
Open the oven door and put the grill heat shield under the control panel using grill heat
shield washers as shown above.
Finally close the door up to it reaches to the grill heat shield
as shown above.
