18
OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
This tool is intended for grinding and polishing metal, as well
as for cutting metal and drilling into metal and wood.
1. CHANGE THE COLLET (SEE FIG. A)
Two sizes (3.2mm pre-assembled, 2.3mm as an accessory) of
collets are provided to accommodate the different accessories
shank sizes.
When using an accessory with a smaller or larger shaft, you
will need to change the collet which matches the shank size of
the accessory, as follows:
Press the spindle lock button. Loosen the collet nut (1) with
the spanner provided. Remove the collet nut (1) and then fully
insert the appropriate size collet into the spindle.
Reinstall the collet nut (1) finger tight. Do not over-tighten the
nut when there is no accessory in the collet.
WARNING!
Fully tighten the collet nut before
operation. Always use the collet which matches the
shank size of the accessory you plan to use. Do not
force a larger diameter shank into a smaller collet.
