23
CHARGING PROCEDURE
1. Plug the charger into an appropriate power supply. When
connected, there will be a green LED light.
2. Insert the charger plug (12) into the charging hole (A1) in
battery pack (10), make sure the plug is fully in position.
The light on the charger will turn red and the three green
LED lights on the battery pack will flash alternately.
3. The battery pack will be fully charged in 2.5hrs. When fully
charged, the LED light on the charger will turn green and
the three LED lights on the battery pack will stop flashing
and stay green.
Important charging notes
Longest life and best performance can be obtained if the
battery pack is charged when the air temperature is between
18-24
o
C. Do not charge the battery pack in a very low or
very high air temperature. This is important and will prevent
serious damage to the battery pack.
1. When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
2. The charger and battery pack may become warm to touch
while charging. This is a normal condition and does not
indicate a problem.
12
10
A1
A2
