33
The motor industrial truck could not carry passengers, except for equipped with the facility for the
passengers sitting.
The driver should pay special attention to the operating circumstance, including the person nearby
other staves and fixed or moving substances, and it is necessary to watch out for the passerby at any
moment.
No matter whether there is load on the lifting part of the truck, it is forbidden anyone passing or
standing under the lifting part of the truck.
If the people, building, organization or equipment accident happens, it is necessary to report to the
relevant officer at once.
The driver should not change, add or demolish the truck components without the permission to
influence the performance of the truck .It is not allowed to install accessorial frame or handle on the
steering wheel ,except the factory has installed it.
The driver should use the truck in the using range. When operating high stacking job, convey high
and multi-piece piled goods using driving type high-lift truck, it is necessary to use the truck with
blind goods shelf and canopy guard shelf.
Exception: if there is no danger of the load fall down on the driver, the truck without blind goods shelf
can be used.
When operating high stacking job, convey high and multi-piece piled goods using walking type truck,
the blind goods shelf is necessary.
14.2.2 Load carriage (lifting and stacking) rule
14.2.2.1 Load
The industrial truck or the combination of the industrial truck and attachment only can convey the
load not over its rated load weight. The capacity of the industrial truck with attachment maybe less
than the one marked on the nameplate.
Any measure of enhancing the capacity of the truck is forbidden, for example the adding people or
balance weight.
In any conditions, especially when using the attachment, it is necessary to pay attention to the
operation, location, fixation and transportation of the load. The truck with attachment when
unloaded should be treated as with some capacity.
Only the rank stabilized or safety load can be conveyed, especially when convey the super long or
high load, should pay special care.
When convey the load which center of gravity is uncertain, operating the vehicle should special
carefully.
14.2.2.2 The loading and unloading of goods.
When loading the goods with forks:
A
）
The space between the forks should fit the width of the conveying load.
B
）
The fork should insert into the inner of the load as deep as possible. But pay attention to not
make the fork tip touch the substance except the load. Then the fork should lift to the enough
height to move the goods.
C
）
When conveying high and multi-piece piled goods, it is necessary to tilt the mast back ward a
little (if can tilt back) to stabilize the load, and should be careful specially.
When unloading the goods, it is necessary to descend carefully. If possible, tilt the mast forward
a little (or limited)in order to put ready the load and draw out the fork.
14.2.2.3 Stacking
When stacking, the mast should tilt backward to ensure the stability of the load, approach the goods
