Prepare By: Dreamis So
P.13
2/13/04
Wall Mounting
THE GH5811 CAN BE MOUNTED ON A STANDARD WALL PHONE PLATE. IF
ONE IS NOT AVAILABLE, IT CAN ALSO BE MOUNTED ON TWO SCREWS (NOT
INCLUDED), INSTALLED 3-1/4” APART VERTICALLY IN THE WALL. LEAVE
3/16” OF EACH SCREW EXPOSED FOR MOUNTING THE UNIT.
A. Connect the wall mount stand to the bottom of the base in the wall mount position.
You can remove the bracket from the base by pushing on the bracket tab.
B. Place one end of the short telephone line cord into the modular jack marked
TEL.LINE located at the back of the base.
C. Place the other end of the line cord into the recessed area in the bottom of the wall
mount stand, and plug into the telephone wall jack.
D. Connect the DC adaptor into the back of the unit and plug the other end to the
110/120 volt AC outlet.
E. Position the wall mount slots on the bottom of the bracket over the two studs on the
wall plate. Pull down and lock into place.
Keep antenna on base at a fixed length for best reception.
F. Place the handset into the base. Make sure that the handset guide (on the base) fits
securely into the slot underneath the handset earpiece. The handset will beep, and the
CHARGE LED will light. The LCD should display “Initialization” for 2 minutes and
then return to standby mode display. During these 2 minutes, user can pick up the
phone and operate it in standby mode.
Handset Battery Charging
The battery pack in the handset must be fully charged for about 16 hours before using the
telephone.
Note:
a. When the battery gets low, there will be a low-battery beep from the handset. The
handset will display “BATTERY LOW” on the second line of the LCD.
b. If the battery becomes low while you are on a call terminate the call quickly and put
handset in the base to recharge the battery.
c. Remember to plug in the battery adaptor. Otherwise, there will be no response.
d. The battery will hold its charge for several days out of the cradle, depending on use.
To Replace Batteries
1. Remove battery cover
2. Remove old battery
3. Install new battery
4. Close battery cover.
5. Place the handset on the base unit. In the first 2 minutes, the LCD will display
initialization in first time uses.
I
N
I
T
I
A
L
I
Z
A
T
I
O
N