1. Insert the Star Drive Key through the slot in the Flanged
Spacer and Gear Head, and use the Spark Plug Wrench
provided to remove the Blade Nut by turning clockwise.
(see Fig. 1) Remove the Blade Nut, Cupped Washer, And
Flanged Spacer.
2. Remove the Flanged Spacer, and then use the Star Drive
Key provided to remove the 3 screws from Gear Head at the
end of Shaft (see Fig. 2).
3. Install the 3 screws through the Trimmer Guard into the
Gear Head (see Fig. 3). Tighten the screws securely.
4. Put on the Flanged Spacer, and align the slot in the
Flanged Spacer with the slot in the Gear Head (see Fig. 4).
5. Insert the Star Drive Key through the slot in the Flanged
Spacer and Gear Head (see Fig. 5).
6. Hand tighten the Trimmer Head Assembly onto the
shaft of the Gear Head by turning counter-clockwise (see
Fig. 6).
7. Tighten the Trimmer Head Assembly securely by rotating
the provided Spanner Wrench counter-clockwise (see Fig. 7).
8. Remove the protective cover from the trimmer line knife
(see Fig. 8).
The Trimmer Line Knife is sharp and can cut you (see Fig. 8).
CAUTION
Assembly
(Continued)
• Save all instructions
To Assemble Trimmer Guard:
A
To Adjust Front Handle:
B
The Front Handle on your Trimmer is adjustable for
your comfort, and requires adjustment from its shipping
orientation before your first use of the Trimmer. To adjust
the Front Handle:
1. Loosen wing nut on the Front Handle.
2. Adjust Front Handle to desired position and re-tighten
wingnut until the handle is secure (see Fig. 9).
Questions? Call Toll Free at 1-800-737-2112
5
Copyright © 2009 MAT Engine Technologies, LLC
Fig. 2
ALIGN HOLES
Fig. 3
Fig. 5
Fig. 4
TIGHTENING
Fig. 9
Fig. 6
TIGHTENING
Fig. 7
Fig. 8
ALIGN SLOTS
TIGHTENING
FLANGED SPACER
SLOTS
Fig. 1
LOOSENING
FLANGED
SPACER
CUPPED
WASHER
