8
ELECTRICAL INSTRUCTIONS
ELECTRICAL REQUIREMENTS:
120 Volts A.C., 60 hz.,
2 wire, single phase,
15 amp wiring required.
WARNING:
CHASSIS MUST BE GROUNDED TO PREVENT POSSIBLE SHOCK HAZARD.
DO NOT ASSUME A PLUMBING LINE WILL PROVIDE SUCH A GROUND.
WARRANTY IS VOID IF UNIT IS CO NNECTED TO ANY VOLTAGE OTHER THAN
SPECIFIED ABOVE AND ON NAMEPLATE.
1. Electrician must provide the conduit and wire for hookup.
2. Power is to be left OFF throughout installation.
3. Electrical Service is connected to the Terminal Block in the lower right side of the service
compartment.
4. If venting or gas connections are to be done later, be sure that power is OFF.