-68-
For Machines Mfg. Since 5/11
13" x 40" Heavy 13
®
EVS Lathe
M A I N T E N A N C E
One-Shot Oiler
The one-shot oiler shown in
Figure 107
lubricates the saddle ways with oil from the
apron reservoir.
To use the one-shot oiler, pull the pump knob
out for two or three seconds and then push it in.
The pump draws oil from the apron reservoir
and forces it to the way guides. Repeat this
process while moving the carriage and cross
slide through their full range of movement to
distribute oil along the ways.
Lubricate the ways before and after operating
the lathe. If the lathe is in a moist or dirty
environment, increase the lubrication interval.
Check the apron oil level through the sight glass
before using the one-shot oiler.
Longitudinal Leadscrew
Oil Type ...... Mobil Vactra 2 or ISO 68 Equivalent
Oil Amount ............................................ As Needed
Lubrication Frequency ................................... Daily
Before lubricating the leadscrew, clean it first
with mineral spirits. A stiff brush works well to
help clean out the threads. Make sure to move
the carriage out of the way, so you can clean the
entire length of the leadscrew.
Apply a thin coat of oil along the length of the
leadscrew. Use a stiff brush to make sure the oil
is applied evenly and down into the threads.
Note:
In some environments, abrasive material
can become caught in the leadscrew lubricant
and drawn into the half nut. In this case,
lubricate the leadscrew with a quality dry
lubricant.
Figure 107. Location of one-shot oiler on the apron.
One-Shot
Oiler
Summary of Contents for SB1051
Page 136: ...Printed In U S A TS14550...
