For Machines Mfg. Since 8/09
Model SB1017
-13-
P R E P A R A T I O N
Assembly
To assemble the bandsaw:
1.
Attach the front and rear panels of the stand
together as shown in
Figure 7
with (6) M8-
1.25 x 15 hex bolts, (6) M8-1.25 hex nuts hex
nuts, and (12) 8mm flat washers.
Figure 7. Front and rear panel assembly.
Figure 9. Left side panel assembly.
Figure 8. Handle installation.
Figure 10. Stand assembly.
2.
Place the assembly upside down on wood
blocks to avoid scratching it or damaging the
mounting tabs.
3.
Attach the handle to the left side panel as
shown in
Figure 8
with two M8-1.25 x 15
hex bolts and 8mm flat washers.
4.
Attach the right side panel (the side without
the handle) to the stand assembly as shown
in
Figure 9
with (7) M8-1.25 x 15 hex bolts,
(7) M8-1.25 hex nuts, and (14) 8mm flat
washers.
5.
Repeat the above step for the right side
panel using (6) M8-1.25 x 15 hex bolts,
(6) M8-1.25 hex nuts, and (12) 8mm flat
washers (see
Figure 10
for assembled view).
x6
x2
x7
Front Panel
Rear Panel
Handle
Left Side Panel
Stand
Assembly
Right Side
Panel
