SA241
Lunar Phaser User’s Guide
26
Specifications
Dimensions
Length: 11.63 cm (4.58 inches)
Width: 7.00 cm (2.75 inches)
Height (not including knobs and footswitch): 3.71 cm (1.46 inches)
Height (including knobs and footswitch): 5.61 cm (2.21 inches)
Weight
280 grams (0.625 pounds)
Power
180 mA @ 9V DC (max 220 mA with Hot Hand Wireless Adapter)
Negative tip (positive sleeve) barrel power jack, 2.1 mm inner diameter, 5.5 mm outer diameter
Audio Performance
Maximum Input Level: +6 dBV = 8.2 dBu = 2 V RMS = 5.6 V p-p
Input Impedance: 1 MegaOhm (1 M
Ω
)
Output Impedance: 600 Ohm (600
Ω
)
108 dB DNR Audio Path
24-bit Audio Conversion
56-bit Digital Data Path
Universal Bypass
TM
(relay-based true bypass and analog buffered bypass)
Troubleshooting
General
Restore factory settings:
In order to revert the Lunar to its factory settings, clearing all user data,
presets, expression mappings and custom effect types, use the Neuro App or USB Editor and choose
the Factory Reset option.
Noise
Power source:
Ensure that the proper power supply is being used.
Near noise source:
Move pedal away from power supplies and other equipment.
Other equipment:
Remove other effects from signal chain; see if noise persists.
Bad cables:
Swap out audio cables.
USB ground loop:
When connected to a computer using a USB cable, noise can appear in the audio
signal. This usually results from ground loop noise due to the Lunar and computer running on
separate power supplies. In the case of laptops, the noise can often be mitigated by disconnecting
the computer’s power supply and running it on a battery. External display monitors are often the
primary source of noise, and powering down monitors can also resolve noise issues.