INSTALLING FREEWHEELIN TO HELMET
1) Locate 3 pieces of Dual Lock to be applied
to helmet exterior
2) Locate installation point for the
FreeWheelin amp along rear of the helmet
3) Apply 1” square Dual Lock at this location
and press firmly for 20-30 seconds. Do not
apply Dual Lock to the Styrofoam portion
of the helmet
4) For helmets with a pointed back — use
amp Dual Lock adapter (included)
5) Locate left/right ear level installation points
for placement of FreeWheelin speaker pods
6) Apply ½" x 2" Dual Lock strips along left/
right locations and press for 20-30 seconds
7) Position FreeWheelin amp over Dual Lock
at rear helmet location and press on
8) Position FreeWheelin speaker pods over
Dual Lock along left/right sides and press on
Installation Notes:
The amp adapter (Dual Lock with rubber square) provides a flat area for attaching the amp on
helmets with pointed backs. Be sure area is completely dry and clean of all dirt, oil, etc. before installing Dual Lock.
To allow proper bond strength for Dual Lock adhesive, do not remove FreeWheelin amp/speaker pods for 24-48 hours
when first applied to the helmet. Removing FreeWheelin components sooner may result in Dual Lock strips coming loose.
The amp doesn’t require a large contact area, so if the Dual Lock is only partially making flat contact, you will find it is
still secure.
Dual Lock
Dual Lock
Dual Lock
Summary of Contents for FreeWheelin
