GND
REM
+12V
POWER
INPUT
RMD
This drawing is for illustration purposes only!
We recommend using 12 AWG speaker cables to obtain increased performance.
Run 12 AWG speaker cables from your speakers to the amplifier’s mounting location
Keep the speaker cables separate from the power cables and and the amplifier’s input cables.
Use grommets where the cables have to penetrate the vehichle chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 1cm, 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause short circuit.
Connect the cable ends to the amplifier as shown in the speaker wiring diagram.
+12V
), GND, REM Connection
(B+
GROUND
Remote
turn on
12V BATTERY
HEAD UNIT
Recommend fuse rating
(See the page 8)
Speaker connection
(SP-6K DFR / SP-8K DFR / SP-12K DFR)
INPUT
REMOTE
GAIN
Max
Min
FREQ.
100Hz
10Hz
HPF
BASS
BOOST
12dB
0dB
FREQ.
LPF
LOW
HIGH
PRT
PWR
CLIP
LEFT
RIGHT
500Hz
50Hz
x1
x5
1.5KHz
50Hz
15KHz
500Hz
x1
x10
SPEAKER
OUTPUT
INPUT
MODE
+
-
Speaker
Impedance
1~8 ohms
Impedances lower than the specified rating (1 ohm) at the output can activate
the short-circuit protection. Likewise, excessive signal distortion will activate the internal
protection system leading to product shutdown. In this case, turn amplifier off, attenuate level
and then turn on amplifier.
NOTE
Minimum impedance is 1 .
5
(SP-6K DFR / SP-8K DFR / SP-12K DFR)
Summary of Contents for SP-6K DFR
Page 8: ...MADE IN KOREA ...
