PMP2BKUMB1 0221
2
PNT3BKUMB4 2016-2021 Dodge Durango Under Mirror Mount Bracket Kit
For Intersector Surface Mount & mpower
®
NOTICE:
Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.
Improper use or installation may void warranty coverage.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com//tech-services/returns/
.
If you have questions regarding this product, contact
Technical Services
, Monday - Friday, 8 a.m. to 5 p.m. or after hours 5 p.m. to 8 p.m. ET at
1.800.338.7337
(press #4).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
1.800.338.7337 / www.soundoffsignal.com
PNT3BKUMB4 0221
INSTALLATION
1. Clean the top of the bracket and the underside of
the vehicle mirror with alcohol pad to ensure a clean
mounting surface.
2. Apply VHB adhesive to the top of the mounting bracket,
as seen in FIG. 1
3. Cut Thin Gasket material in half (3”) and apply to the
edge of the bracket that rests on vehicles paint.
4. Mount the bracket to the under side of the mirror in the
desired position. Make sure the bracket is not resting on
the painted surface. Apply pressure for 30 seconds to
ensure bracket is attached to mirror, as seen in FIG. 2
5. Remove the mirror housing from vehicle according to
the manufacturer specs.
6. Using the screws holes in bracket as a guide, drill holes
for the stainless screws with a 7/64” drill bit (be careful
not to damage wiring in mirror housing.) Install provided
stainless screws through bracket into mirror housing.
Tighten until screw is snug, as seen in FIG. 3
7. Mount light onto bracket with hardware provided with
the light and run wires into mirror. A hole may need to
drilled to create a path for the wires, as seen in FIG. 4
8. Re-install the mirror and tighten to manufacturer specs.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
Place bracket
under mirror
NOTE: MAKE SURE THE MOUNTING HOLES ARE NOT
COVERED BY THE VHB STRIP
NOTE: WHILE MOUNTING THE BRACKET ENSURE THE
LIGHT IS PARALLEL TO THE GROUND.
