10
TROUBLESHOOTING
Problem
Possible cause
Solution
The appliance
cannot be switched
on.
The power cable (25) is not properly
connected.
The batteries are not correctly inserted or the
batteries are not charged.
Check that the power cable (25) is properly
connected.
Check that the batteries are properly
inserted or replace discharged batteries.
No sound or sound
interference.
The volume is set too low.
The inserted disc is dirty or scratched.
Set the volume higher.
Clean the disc with a soft cloth or insert
another disc.
Poor FM reception,
or no stereo.
The FM antenna is covered.
The band switch (19) is not set to
FM ST
.
The band switch (19) is set to
FM ST
.
Set up the antenna to improve reception.
Set the band switch (19) to
FM ST
.
Set the band switch (19) to
FM
. to decrease
noise.
Skipping of tracks
during playback.
The inserted disc is dirty or scratched.
Playback in program mode.
Clean the disc with a soft cloth or insert
another disc.
Stop the program mode.
CLEANING AND CARE
General
Disconnect the power plug (25) from the wall outlet prior to each cleaning.
Clean the casing with a slightly damp cloth.
Do not, under any circumstances, use chemicals, alcohol or other harsh agents to clean the casing.
Handling CD’s
A small amount of dust or scratches will usually not have an impact on the quality of a disc. The
discs should, however, be treated with care.
Protect your compact discs from dust and scratches.
Store your compact discs in their covers when not in use.
To maintain the original quality of sound, you should occasionally wipe your compact discs with a
soft cloth, from the centre to the edge (not with circular movements). Never use gasoline or other
solvents.
Only hold a compact disc by its edges!
