SOUNDMASTER SCD-5600, Instruction Manual

Page: 7 / 9

6
Note:
•
To ensure good system performance, wait until the disc tray completely reads the disc before
proceeding.
•
If no disc loaded into the compartment, or the disc is place upside down or unreadable, the
display will show “
00
”.
Playing a disc
1. Press CD PLAY/PAUSE button to start playback. The playback starts from track 1, the CD
PLAY/PAUSE indicator inside the right lower corner of the display illuminates.
2. To interrupt playback, press the CD PLAY/PAUSE button. The CD PLAY/PAUSE indicator
flashes on and off.
3. To resume playback, press the CD PLAY/PAUSE button again, the CD PLAY/PAUSE
indicator becomes steady on the display.
4. To stop playback, press the CD STOP button, the total number of tracks appears in the
display.
Selecting a desired track/passage
To select a desired track
•
Press SKIP/SEARCH FORWARD/BACKWARD button repeatedly in stop mode or during
playing until the desired track appears on the display.
•
Press PLAY/PAUSE button to start play.
To search for a particular passage during playback
(track scanning at high speed)
Press and hold SKIP/SEARCH BACKWARD/FORWARD button to scan the current playing
track at high speed until desired point (passage), then release the button.
Playback will start again from this point.
Program tracks
Programming tracks of disc are possible when playback is stopped. Up to 20 tracks can be
stored in the memory in any order.
1. In stop mode, press the PROGRAM button, the
01
will flash and the PROGRAM indicator
will be on.
2. Press the CD SKIP/SEARCH FORWARD button to select the first desired track to be
programmed.
3. Press the PROGRAM button to enter. The display changes to show
02
flashing.
4. Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5. Press the PLAY/PAUSE button to start playback from the first programmed track.
6. Press the STOP button to stop program playback.
Note: Program function can only be done in stop mode.
To Erase the Memory (Program)
To clear the program, you may have two ways:
1. Press STOP button when the disc stopped, or
2. Open the CD compartment lid, program will be erased.