IR1100 / English Instruction Manual
2
INITIAL USE
Before operation, please make sure that the VOLTAGE mentioned on the power supply is same as the
voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains socket.
Switch the device on with the power switch (12) on the rear. Then press
“STANDBY” (2) on the front to
wake the device up from standby mode.
When it is the first time running the device, the system will ask you to set Language and Network
configurations. You may setup the network connection immediately, or set it later. Use
“Navigate” (10)
to select the desired option. Press
“Navigate/OK” (10) to confirm.
Network configuration
1. Normal network configuration
Select
“Yes”
for the normal Wireless Network Configuration: The select the required AP by turning
“Navigate” (10) and confirm it by pressing “Navigate/OK” (10).
Enter WEP or WPA code to connect the WiFi network by select the correct character turning the
“Navigate/OK” (10) button.
Press “Forward” (9) button to select the next character.
In this condition, press
“Back” (7) button you can turn left and delete the left characters at the same time:
When the password is complete please press
“Navigate/OK” button (10) to confirm.
Note:
Below characters are available for the radio:
Numbers(from 0-9)
English letters(from A to Z and from a to z)
Other characters (@
,!,”,#,$,%,&,*,’,+ and (,)
2. WPS PBC network configuration
Select “Yes WPS” when you would like set up with Wireless Network (WPS PBC) feature: If you are
using a router with WPS button, you may set up the network connection simple via WPS function. Enter
it and go to press the WPS button on your router within 120 seconds.
The connection between the router and the Radio will then be configured automatically
Select “No” when you not want to install the network at the moment.
3. No network configuration
Pls.
select “No” when you don’t like to configure the network connection at the moment.
Press
“STANDBY” (2) for standby. When the actual date and time is shown the network is configuration is well
done. Date and time, as well as alarms-if activated-will still are shown on the display when in standby mode.
