EN - 8
CONNECTIONS
A. Terminals for two loudspeakers (minimum speaker impedance 8 ohm.) Attach loud
speaker cables to the unit. Left speaker: connect the wire
to terminal ‘L’. Right speaker: connect the wire to terminal ‘R’.
B. Terminal for FM antenna. The antenna wire supplied with
the unit can be connected to terminal. Adjust the position
of FM antenna for optimum reception. For good FM stereo
reception, use an FM outdoor antenna or connect the
supplied antenna wire to your house distribution system.
C. Voltage selector (not on all version). If your version has
this selector, check that the setting corresponds with your
local mains voltage. If the selector must be reset, disconnect
the AC power cord.
D. AUX input. For connection of other sound sources. (e.g. TV or VCR audio output).
OPERATION
POWER STANDBY ON/OFF
When you
fi
rst plug the unit and select the ON/OFF switch to turn on the mains, the unit
will go into standby mode. The display will show the time.
1. You can press POWER to switch on the unit.
2. The standby function of the unit remains on until the unit is switched on.
3. Pull the main plug out of the wall socket if you want to switch off the main voltage
completely.
4. For wall-mount apparatus,the unit and speaker boxes can be mount to the wall b
y fixing
screws.
OPERATION/CLOCK SETTING
1.
Under standby mode, press MEM key for
2. Press and hold MEM, the hour digit
correct hours.
06300174 Soundmaster M373PR1 IB(EN).indd Sec1:8
11/29/2006 9:32:32 AM
2 seconds to access clock setting.
will
fl
ash, press
F
or
B
to set the
3. Press MEM again to select the minutes setting, the minute digit
set the correct minutes.
4. Press MEM again to store in the memory.
will
fl
ash, press the
F
or
B
to
