background image

USING SDX4.1

  6

The SDX4.1 crossover aims to divide and direct the musical 
signal according to each audio frequency range, sending this 
signal to the amplifiers and consequently to the loudspeakers. 
The correct frequency division guarantees the sound system a 
higher performance, since each type of loudspeaker  works at 
different  frequency  ranges,  in  wich  they  perform  best.  In 
addition,  the  loudspeaker,  by  working  only  with  suitable 
frequencies,  gets  the  most  protection  avoiding  accidental 
damage. When in doubt about the appropriate frequency cuts, 
always consult the loudspeaker manufacturer.

 The  SDX4.1  has  two  audio  inputs  called  Front  In  and  Low 
/Rear In. The Front In input is responsible for receiving audio 
signal and sending it to the Flat, Mid Low, Mid High, and High 
outputs. The Front In signal can also be directed to the Low 
channel  through  the  switch  key  located  just  above  the  Low 
/Rear input; the Low /Rear input is used exclusively to send 
audio to the Low output. This input can be connected to the 
Rear  or  Sub  outputs  of  the  car  radio  if  it  is  available  in  the 
device  used.  Connection  to  the  Low  /Rear  input  is  not 
mandatory,  and  the  Low  output  may  also  receive  audio 
through the Front In. The Front /Rear switch is responsible for 
this switching.

In the Front In, we also have 2 (two) adjustment switch keys, a 
mono /stereo switch key and another Phase switch key. The 
mono  /stereo  switch  key  is  used  to  mix  (add)  the  input 
channels L and R into a mono signal that is sent to the outputs. 
In  the  stereo  position,  the  stereo  channels  L  and  R  are 
separated from the output channels. The Phase switch effects 
a 180° phase rotation on the audio signal from the Front In 
input, sending the Mid Low, Mid High and High outputs. This 
rotation is important in cases where you have another sound 
system connected to the Flat output of the SDX4.1. 
 

By performing the phase rotation 0/180º we can avoid phase 
cancellations  from  one  system  to  the  other,  having  an  add 
effect of the sound pressure. This feature is useful when you 
are linking multiple vehicles to play the same musical program.

Summary of Contents for SDX4.1













Reviews: