5
25. Connect the black ground wire to the bolt directly above the
hood release lever. Torque to 9Nm, +/- 1.5Nm. Fig. 12
26. Continue running the subwoofer harness down the drivers
side of the vehicle to the back of the cab and then over to the
passenger’s side under the carpet. The end of the wire needs to
come out from under the rear passenger’s seat approximately in
the center and on top of the carpet in front of the seat belt recep-
tacles.
NOTE: If you are installing the optional amplifi er system, refer to
the amplifi er instruction manual to complete the installation.
Subwoofer Mounting
27. Remove the most forward rear passenger’s side seat nut located by the door opening.
28. Remove the nut securing the rear seat buckle assembly and remove temporarily. Fig. 13
29. Connect the subwoofer wiring to the subwoofer harness and place the enclosure over the seat stud and
the seat buckle stud. Make sure the connectors are not pinched between carpet and subwoofer enclosure.
Fig. 14
30. Replace the rear seat buckle assembly over the top of the subwoofer bracket and reinstall the factory
nut. Tighten the nut to 53 Nm (39 ft/lb)
31. Replace the rear seat nut and tighten to 109 Nm (80 ft/lb)
32. Install fuse into fuse holder.
33. Reinstall all previously removed parts in reverse order.
34. Reconnect negative battery cable. Torque to 17Nm.
Troubleshooting the Kicker Integrated Systems
Connect
ground
wire here
If you continue to experience problems after troubleshooting, please contact KICKER Technical Support at
(800) 256-0808 ext. 6009, or
. Place your warranty card in the glove box for future
use, and the hang-tag on your mirror.
Summary of Contents for SSICRE07
Page 8: ...8...
