Rearview camera:
If you have installed a rearview camera system, and have the
camera video signal connected to
Video 1, with the grey Source 1 trigger wire fed from the back up light circuit, when you
put the vehicle in reverse, the VIDBMW1V4 will automatically switch the screen display
to the rearview camera.
Adjusting picture quality:
VIDBMW1V4 module is equipped with brightness, color and
contrast adjustments.
Note:
Adjustments affect both Video 1 and 2 equally (cannot be
set individually).
VIDBMW1V4 OPERATION
30
86
85
87a
87
+12 Volt ACC “trigger”
from Source 2 (if present)
Bosch Relay
(not included)
Ground
Ground
Ground “trigger” from
Source 2 (if present)
Black - trigger wire
to activare Source 2
White 7-pin connector
with single black wire
Manual Latching-type
single pole, single throw
switch (not included)
Chassis ground
30
86
85
87a
87
Ground “trigger” from
Source 1 (if equipped)
Bosch Relay
(not included)
+12 Volt ACC (switched)
Manual Latching-type
single pole, single throw
switch (not included)
+12 Volt from back up
light circuit (hot when
vehicle is in reverse)
OR
+12 Volt “trigger” from
Source 1 (if equipped)
White 16-pin
connector
Red
Black
Blue
+12 Volt ACC (switched)
Chassis Ground
Interlock - ground from
hand brake (video
interlock)
Grey trigger wire
to activate Source 1
+12 Volt ACC (switched)
Figure 3 - Source 2 Activation Wiring
Figure 2 - Source 1 Activation, Power, and Ground Wiring
Page 3
VIDBMW1V4 INSTALLATION INSTRUCTIONS
Finish installation
Once testing is done and the system is functioning properly, reinstall all trim
panels removed during installation. Installation is complete!
Step
7
Reinstall radio and test operation
A.
If you have installed a rearview camera, start the vehicle, turn on the radio and
navigation system and put the vehicle in reverse. The navigation display should change
to show the view from the camera. Shifting the vehicle out of park should return you to
the navigation display. If necessary, adjust the brightness, color and contrast with the
controls on the VIDBMW1V4.
B.
If you have installed a video system, with the vehicle in park gear, and the
parking brake on, activate the video source. The navigation display will change to show
the video source.
C.
With the video source active and playing, test the video interlock by taking off the
parking brake. The navigation display should return.
Step
6
