DAT Recorder Setup Guide
15
AES/EBU Output:
Press
<MENU>
, and use the PARAM encoder to scroll down until ‘AES/EBU O/P Set.’ is the
highlighted menu. Press
<ENTER>
and route the AES/EBU output as required, from a choice of
the mix bus, aux outputs 1/2 or 3/4, or FX sends 1/2.
To set the wordlength of the AES/EBU output, press the down cursor from the above menu page.
The wordlength options are 16, 20 or 24 bit. Note that 16 and 20 bit settings are dithered and
24 bit is undithered.
To set the status bits within the AES/EBU output stream * , press the down cursor. By default
the AES/EBU output status bits setting of ‘AUTO’ sets the sample rate flag to 48kHz and the pro
flag to on. To set these manually, you should use the PARAM encoder to set the status bits to
MAN. Press the down cursor again to set the sample rate flag and again to set the pro flag on or
off.
<AES/EBU Output>
Src From: MIX
<AES/EBU Output>
Wordlength: 16
<AES/EBU Output>
S/Rate Flag:44k1
<AES/EBU Output>
Pro Flag: OFF
Individual DAT recorder models may require different settings. Consult
the DAT Recorder Setup section of this setup guide and documentation
specific to the DAT recorder model.
NOTE
