9
Operating the handheld wireless mic/transmitter.
Indicator LED for Power and battery status
Power Button: Press and hold for 2 seconds to turn “on” (
LED
green), press
and hold again to turn “off.”
Group Button: Changes group setting.
Channel Button: Changes channel and gain setting.
LED Display: Displays group and channel setting
Battery Compartment
Changing
batteries.
Install 2 new AA alkaline batteries in the transmitter for best
results; expected battery life is approximately 14 hours.
When the transmitter light
1
glows red, replace the batteries.
Adjusting Gain Settings.
Hold the channel button for 5 seconds. A dot appears on the lower
right-hand corner of the LED display, which indicates -10db gain setting
has been activated.
To change back, hold channel button agiain for 5 seconds until dot
disapears.
8
1
2
3
Wireless system operation.
The Voice Machine VM-2 is available with single or dual
built-in Shure wireless receivers. The instructions on the
following pages describe how to set-up and operate the
receiver units and wireless transmitters.
Operating the optional wireless mic system.
The built-in wireless receiver(s) turn on automatically when
the Voice Machine is turned “on.” Plug the antennas onto
the mating connecotors on the VM-2 as follows: line up
the pins, push inward and rotate clockwise a quarter turn
until they snap in place. Orient the antennas up and out
at a slight angle (see photo); single wireless options will
have two antennas, dual wireless will have four. Also, note the location of the wireless
mic volume controls on the Voice Machine’s rear panel.
Features and controls of the built-in wireless receiver.
audio
LED: Indicates strength of incoming audio signal:
green for normal, amber for strong, red for peak.
ready
LED: Green light indicates wireless system is receiving signal.
Channel number readout: See “Signal System Setup” on page 11.
Group and Channel Buttons
Scan:
Push and release
Group Button
to scan for an open group
and channel.
Manual:
Push and hold
Group Button
to select a group. Push
Channel Button
to select a channel in the current group.
1
2
3
4
wireless mic
wireless mic
one
two
1
2
3
4
4
5
6
5
6
3
4
1
2
4
