29
5.13
Recovery Mode
IR.BL
Network Ethernet cable
pull out
1. Reboot & Ethernet Connection
1-1. Reboot the power by unplugging and
plugging again the power cord.
1-2. Ensure the Ethernet cable is plugged
into LAN port properly.
2. Recovery mode
2 - 1 . Lo n g p re s s S t a n d by b u t to n a n d
Standby light goes red/ green blinking.
2-2. Hold the button until entering recovery
mode.
3.Select Reset mode :
3-1. Restore from Backup : select here to
keep saved settings.
3-2. Install Latest Version : select here to
erase all settings.
3-3. Normal Booting : exit to back to Normal
Mode.
4.Extracting files
Extracting files. Please wait for the process.
5.Installing
Installing. Please wait for the process.
6.Rebooting
O n c e t h e i n s t a l l a t i o n i s c o m p l e t e d ,
rebooting starts automatically.
28
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio,
Pro Logic, and the double-D symbol are trademarks of Dolby Laboratories.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled
environment and it also complies with Part 15 of the FCC RF Rules. This equipment
must be installed and operated in accordance with provided instructions and
the antenna(s) used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter. End-users and installers must
be provided with antenna installation instructions and consider removing the no-
collocation statement.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
SMC-1030 manual_ 20191118.indd 30-31
2019/11/18 下午 04:05:48
