Sound Freaq SFQ-01A, User Manual

Page: 3 / 18

.2.
CAUTION - Proper Ventilation
To avoid risk of electric shock and fire, and to
prevent damage, locate the apparatus as
follows:
Front : No obstructions and open spacing.
Sides / Top / Back : No obstructions should be
placed in the areas shown by the dimensions
below.
Bottom
: Place on the level surface. Maintain an
adequate air path for ventilation by placing on a
stand with a height of 10 cm (3-15/16") or more.
15cm
(5-
15
/
16
")
15cm
(5-
15
/
16
")
15cm
(5-
15
/
16
")
Front View:
15cm
(5-
15
/
16
")
15cm
(5- 15 /
16
")
Side View:
CAUTION - Proper Installation

Install the system in a place which is level, dry
and neither too hot nor too cold. The appropriate
temperature is between 5
o
C and 35
o
C.

Install the system in a location with adequate
ventilation to prevent internal heat from
building up inside the unit.

Leave sufficient distance between the system
and TV.

Keep the system away from TV to avoid
interference with TV.
10 cm (3- 15
/
16
")
Front side Back side
For compatibility between the SFQ-01A system
and another device with Bluetooth technology,
consult the device's documentation and dealer.
In some countries, there may be restrictions on
using Bluetooth devices. Check with your local
authorities.
Bluetooth is a registered trademark of Bluetooth
SIG, Inc
Please read rating label at the bottom of system
for power input and other safety information.
Warning: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
Note:
This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment
and receiver.

Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.

Consult the dealer or an experienced radio TV
technician for help.