7
Setting The Temperature Controls
When press the temperature setting button, the system will enter the set up mode of the
upper or lower compartment automatically. The LED display will flash and show the setting
temperature. After 5 seconds the flash will stop and it will show the actual measured
interior temperature.
Press the button “+” or ”-” once, the temperature will decrease or increase 1
℃
/1
℉
After
stopping pressing the button for 5 seconds, LED figure will stop flash, then revert back to
display the setting temperature of the upper or lower compartment.
After the unit is unplugged, the system will return to default setting temperature, which set
by factory. The default setting temperature as below:
Upper compartment:
The temperature setting can be adjusted from
5
℃
/41
℉
to 12
℃
/53.6
℉
.
Lower compartment:
The temperature setting can be adjusted from
12
℃
/53.6
℉
to 20
℃
/68
℉
.
Model
Temperature range
JC-115 WINE CELLAR
Left zone 5-20ºC (41-68ºF), right zone 2-10ºC (36-50ºF)
Attention
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restart
the unit. If you attempt to restart before this time delay, the Wine Cellar will not start. If first time
use or longer absence of using, the temperature will be different between setting and LED
display temperature. After running a period, the temperature will be reverting back.
Shelves
To prevent damaging the door gasket, make sure to have the door all the way opened
when pulling shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelves approximately 1/3 out of
the rail compartment, however this unit was designed with a notch on each sides of the
shelf tracks to prevent bottles from falling.
Please refer to the following direction for replace shelf with different method.
Please refer to the following direction for replace shelf with different method.
If need to take out any shelf, move the shelf towards the gap on the both sides and
alignment with shelf support A. Then, upwards the shelf and pull out it from the cabinet
once the shelf support disengaged from the gap.