© 2006 SOTA Instruments Inc.
© 2006 SOTA Instruments Inc.
6
7
should not be uncomfortable. See ‘How It Should Feel’ on page 8.
8. Change modes by pushing the mode button. The green light indicates
which mode is selected. See ‘Output of
Six Modes’ on page 9.
9. The timer will automatically cycle the unit
into Sleep Mode after 20 minutes. While
in Sleep Mode, the green mode light will
flash every 2 seconds.
10. While in Sleep Mode the battery is still
being used. Either reset to continue or
turn the unit OFF.
To reset:
a. Push the mode button once for
another 20 minutes using the same mode, or
b. Choose another mode by selecting with the mode button.
HOW TO USE THE BIO-TUNER
1. Wipe the ear lobes to eliminate skin oils. This will allow
for better conductivity.
2. Wet the conductive rubber on the ear clips.
3. Position one clip on each ear lobe. Place as close to the
jaw as possible.
4. Plug the earclip cord into the unit with the flat side of the
plug face up. When the plug is positioned correctly, it will
slide in gently. Do not force.
5. Slide the clip on the back of the Bio-Tuner into the holding
clip on the Arm Clip
and Band.
6. Slide the Arm Clip and Band with
the unit attached up the arm to a
comfortable position.
Tighten the Arm Clip and Band to fit
snugly and comfortably.
Option: If preferred, the unit can be
placed in a pocket.
7. Turn the unit ON and gradually turn
up the intensity. The current may or
may not be felt. If felt, the intensity
Note: The yellow light can be used to check the output of the unit if the current
cannot be felt. The light should come on when the unit is on and the earclips
positioned correctly. The unit may need to be turned up to a higher intensity for
the light to come on. It is not necessary, however, to operate the unit at a high
intensity.
