1.4. - Wall installation
Installation
C.1.4.1
Only install the controller in dry areas and under the ambient conditions described
under 1.1. - „Specifications“. Follow the description below.
1. Carefully pull the upper part of the housing
from the lower part and set the upper part of
the housing aside.
2. Hold the lower part of the housing up to the
selected position and mark the 2 mounting
holes. Make sure that the wall surface is as
even as possible so that the housing does
not become distorted when it is screwed on.
3. Using a drill and size 6 bit, drill 2 holes at
the points marked on the wall and push the
plugs in.
4. Screw the lower part on and hang the upper
part on the lower part from above.
Caution
C.1.4.2
(1)
(2)
(3)
(4)
(5)
(6)
(1)
Reset button
(2)
Two-colour LED lamp for function control
(3)
Micro SD card slot
(4)
Power cord xonnector
(5) Ethernet
(6)
CAN bus (2x)
1.5. - Indicators and connectors
1.6. - Electrical connection
Connect the data logger with the AC adapter included and plug it into the socket. The data logger will start
automatically.
1.7. - Status-LED
The two-colour LED lamp indicates the status and the operation of the data logger.
LED lamp is green:
Micro SD card is correct and CAN bus available
LED lamp is red:
Micro SD card is not correct
LED lamp flashes red:
CAN bus is not correct
Insert the micro SD card into the card slot as shown (contacts above).
Caution
