Sony ZRCT-100, Operating Instructions Manual

Page: 5 / 23

5
Parts Identification
ZRD-1/ZRD-2 Display Unit
Left / rear
Caution
Do not connect the OUT and IN connectors to a hub. The
input/output signals for these connectors are unique to the
product and are not Ethernet signals. In particular, be
aware that connecting these connectors to a PoE injector
hub may result in damage to the product.
a
Unit joints
Connect to other display units.
Two unit joints are located on each of the top, bottom,
left, and right sides of the display unit.
b
Status indicator
Indicates the status of the display unit.
c
- IN (AC power input) connector
Use a power cord (supplied with the ZRD-2 only) to
connect this connector to the
- OUT (AC power
output) connector on the preceding display unit in the
daisy-chain connection.
For the first display unit in the daisy-chain
connection, use a power cord (not supplied) to
connect this connector to the circuit breaker.
d
OUT (unit output) connector (RJ-45)
Use a Category 6a cable (supplied with the ZRD-2
only) or Category 7 cable (not supplied) to connect
this connector to the IN (unit input) connector on the
succeeding display unit in the daisy-chain connection.
This connector is not used for the last display unit in
the daisy-chain connection.
e
IN (unit input) connector (RJ-45)
Use a Category 6a cable (supplied with the ZRD-2
only) or Category 7 cable (not supplied) to connect
this connector to the OUT (unit output) connector on
the preceding display unit in the daisy-chain
connection.
For the first display unit in the daisy-chain
connection, use a Category 7 cable (not supplied) to
connect this connector to the UNIT OUTPUT
connector on the display controller.
a
b
a
f
e
d
c
Indicator Status
Off The display unit is turned off.
Lit yellow The display unit is starting up.
Blinking
yellow A warning has occurred.
For details, see “Troubleshooting” (page 15).
Lit red The display unit is in standby mode.
Blinking red An error has occurred.
For details, see “Troubleshooting” (page 15).
Lit green The display unit is operating normally.