Sony Electronics Inc. • 16530 Via Esprillo • San Diego, CA 92127 • 1.800.222.7669 • www.sony.com
Last Updated: 04/13/2011
XM-GTR2202
2/1 channel GTR amp
Please visit the Dealer Source for current information at
www.sony.com/dealersource
Features
220 Watts x 2 RMS at 4 Ohms
1
440 Watts x 2 max power at 4 Ohms
270 Watts x 2 RMS at 2 Ohms
650 Watts x 2 max power at 2 Ohms
540 Watts x 1 RMS at 4 Ohms
1400 Watts x 1 max power at 4 Ohms
This unit can be used
as a bridging amplifier with a maximum output of 1400 Watts
at 4 Ohms.
High Level input with Sensing Power On
Direct connection
(High Level Input) can be made with the speaker output of
your car audio unit if it is not equipped with RCA line output. Hi-
Level Sensing power On feature allows the unit to be activated
without need for remote connection.
50-300 Hz Variable Low-pass filter, 12 dB/oct
Built in variable
12 dB/Oct LPF (Low Pass Filter) from 50-300Hz enables users to
concentrate the power on lower frequencies.
6-70 Hz Variable subsonic filter, 12 dB/oct
Built in variable 12
dB/Oct Subsonic filter from 6-70Hz enables users to create a
band pass filter and block extremely low frequencies to
improve the subwoofer systems efficiency.
0-10 dB Variable 40Hz Low boost
Variable 0-10 dB 40Hz bass
boost provides additional bass response at lower frequencies.
Specifications
Audio
Frequency Response:
10 - 50 kHz (+0/-3 dB)
Input Level:
0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input)
Impedance:
2-8 Ohms Stereo or 4-8 Ohms Mono
Operation:
2/1 channel configuration
Tone Control(s):
Low Pass Filter: 50-300Hz, 12dB/Oct
Subsonic filter: 6-70Hz, 12dB/Oct
Harmonic Distortion:
0.05% (at 1kHz)
Low Boost:
0-10dB Variable (at 40Hz)
Signal-to-Noise Ratio (dB):
93 dBA
Power
Output Power:
Maximum Output: 440 Watts x2 or 1400 Watts x1
(at 4 Ohms)
Current Drain:
At rated output: 50A (at 4 Ohms)
Remote Input: 1 mA
Rated Output:
(20Hz-20kHz, 1% THD+N, 14.4V) 220 Watts x 2
RMS (4 Ohms)
270 Watts x 2 RMS (2 Ohms)
540 Watts x 1 RMS Mono (4 Ohms)
Power Requirements:
12V DC Car Battery (Negative Ground)
Internal Power Supply:
OTL Output Transformerless Circuit
Pulse Power Supply
1
Input Voltage:
10.5-16V Power Supply Voltage
Inputs and Outputs
RCA Audio Input(s):
Pin Jacks: 0.3 - 6V
Audio In:
RCA Pin Jacks, High Level Input Connector
Audio Out:
Speaker terminals with screws
Dimensions
Weight:
7 lbs. 15 oz.
Measurements:
16 3/4 x 2 1/4 x 11 1/8" (424 x 55 x 280 mm)
Supplied Accessories
Mounting Screws (4)
High Level Input Cord (1)
Protection cap (1)
Color:
Gray and Silver
UPC Code:
027242773066
1. CEA-2006 Compliant — Standardized “Voluntary” Testing & Measurement Methods for Mobile Audio
Amplifiers. This standard advocates a uniform method for determining an amplifier’s RMS power and signal-
to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total
Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to
20,000 Hz.
© 2010 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without written permission is
prohibited. Sony, Quick-BrowZer, Walkman, Xpl
ō
d, ZAPPIN, and the Sony and Xpl
ō
d logos are trademarks of
Sony. iPod is a trademark of Apple Inc. All other trademarks are trademarks of their respective owners.
Features and specifications are subject to change without notice. Non-metric weights and measures are
approximate and may vary.
